Slat Type Chip Conveyors
These conveyors are mainly used for long curly chips ideal for steel chips. It’s also called cleat type conveyors. it’s nothing but a hinged belt attached with the chain on its surface to avoid any entangling of chips with the conveyors.
Scraper Type Chip Conveyors
These conveyors are mainly used for smaller chips. Especially for cast iron chips. Scrapers are tied between the chains that are running on the sprockets mounted on shafts. These scrapers carry the chips to the chip trolley.
Oil Skimmer Belt type & Online
Oil skimmer type/disk type are specially designed and are manufactured to meet the requirement of modern industry.The Oil Skimmer is used to separate the tramp oil from the coolant.
Screw & Coil Conveyor
SCREW CONVEYORS are used for powder materials, with low powder coats and a minimum powder emission. The screw conveyor has a constant volumetric according to speed. It may be exposed to a head of material and by having a correctly designed flight and with variation in the speed can be used to control and feed equipment at a uniform metered rate down the process stream, eliminating surges in the process. In many situations it is the only device that can be used as a feeder.
Magnetic Chip Conveyors
These conveyors are mainly used for the small wet ferrous chips. This helps in recovering the costly fluids that are used for machining. When the chips fall on the magnetic conveyor (stainless steel) l that is stand still. Conveyors is running below the stainless steel sheet. Magnets are connected to the chain. Chips stick to the magnets & are carried to the chips Trolley. Oil/Coolant is recovered back to the tank.
Magnetic separation is a filtration process in which ferromagnetic or paramagnetic particles are removed from a process line. The process is achieved by applying an electrical current to a wire mesh or matrix, thereby including a magnetic field. When a solution or gas is passed through the mesh, any magnetic particles are attracted to the focus of the magnetic field and are filtered out of the flow.
WORKING The contaminated coolant from the machine is fed into the inlet of magnetic separator. The dust particular are attracted and arrested by the magnetic drum. The magnetic drums attracts the dust particles when it goes between body and drum with the help of a scrapers dust and allows squeezes by a synthetic rubber roller mounted on the spring drive power stored into the dust collecting tray.